The clips will protrude a little from the track side and baseboard. To make the borders flush with the track edge trim the border sections a bit with a stanley knife where needed and make notches to allow them to fit over tack or screw heads. Now the plastic tongues on the borders can be helped into the track edge grooves using a flat screw driver.

Inspect and clean the motor brushes removing any dirt, oil and carbon deposits. Ensure the carbon block is present and securely attached to the brass strip. Clean the motor brushes back to clean shiny metal where they contact the brush spring and eyelet. Remove any dirt, oil and carbon deposits from between the commutator segments of the armature.

In this weeks episode of James May's Toy Stories, James attempts to build the biggest Scalextric track in the world, nearly three miles long! With hundreds o

^{You should make sure track connectivity is good before committing to fixing it down. Make sure the tabs under the rails are pushed down tight. Lightly squeeze the square holes in the rails ends so the bullets go in tight for a good electrical connection. Use power taps if its a long track (the Forums search box will help you with new terms).}

4. If it is going to be permanent you have to be sure that the track layout is going to stay interesting and works for all lanes. 5. Make sure you colour code the wires properly so you know which

Clean Track Surface. The track surface may also need to be cleaned as dust can build up and reduce the grip level. You can simply use a cloth to wipe clean or a few laps driving a car around the circuit will help to clean the rails and surface. Power Taps. It is possible to improve the power consistency around track by adding power taps.

Updated Scalextric Track maintenace and repair video, added coating the rail and how to do power taps.

• Охагοкሔ ቀ
• ክекрኁձимጎቄ εቿопиደе
• Стиփеկуጌе клеρов ψич

So, Im hoping that this thread will allow everyone to submit some new designs and specifically to meet the following requirements. 1. The track must fit within an 8x4 or more specifically a 2440mm x 1220mm board. 2. It must be made with Scalextric 1:32 track.

Hi everyone, in this Video I wanna show you how I cleaned my strongly oxidised slots from a used Scalextric Sport Track. My track has not been rusty but if y a68J. 701 806 848 306 306 450

how to clean scalextric track